Area Boundaries; Privacy Zones - American Dynamics SpeedDome Ultra VII Quick Reference Manual

Area Boundaries

AREA BOUNDARIES
12
PAN to start of BOUND 1-16
PAN RIGHT ONLY
ZOOM to mark BOUNDARY
FOCUS saves and exits
Up to 16 areas may be programmed. These areas are
separate from areas that may be available through your
switcher.

Privacy Zones

13
ADD PRIVACY ZONES
DELETE SPECIFIC ZONE
DELETE ALL ZONES
HIDE ALL ZONES? NO/YES
In addition to hiding all programmed privacy zones, this
screen provides links to lower level screens. See the
following screens:
• Add Privacy Zones (Screen 14)
• Delete Privacy Zone (Screen 15)
• Delete All Zones (Screen 16)
SPEEDDOME ULTRA VII 22X DOME CONFIGURATION UTILITY QUICK REFERENCE GUIDE (8200-0184-03, REV. C)
PRIVACY ZONES
EXIT
Add Privacy Zones
14
Navigate to corner 1(2, 3)
• Up to 8 Privacy Zones may be programmed.
• Three points must be selected to establish the
Privacy Zone. The fourth point is automatically
calculated.
Use the Pan/Tilt control to position the arrows over
•
the selection point. If arrows blink, this is not a valid
selection area.
• Press Zoom to save the point.
Delete Privacy Zone
15
• Arrows must be clearly positioned in zone to delete.
• Use the Pan/Tilt control to position the arrows over
the zone. If arrows blink, this is not a valid selection
area.
Press Zoom to delete the selected zone.
•
4 of 7
NEW PRIVACY ZONE
ZOOM to Mark Corner
FOCUS to Abandon Zone
Navigate to zone
ZOOM to delete zone
FOCUS quits w/o changing