Beko 674581 EB User Manual page 37

Place the product on a clean, flat
and solid surface and balance it
with adjustable feet. Otherwise,
the product may tip over and cause
injuries.
The installation location must be
dry and well ventilated. Do not
place carpets, rugs or similar covers
under the product. Insufficient
ventilation causes the risk of fire!
Do not cover or block the
ventilation openings. Otherwise,
power consumption increases and
your product may get damaged.
Product must not be connected to
supply systems such as solar power
supplies. Otherwise, your product
may get damaged due to sudden
voltage changes!
The more refrigerant a refrigerator
contains, the larger the installation
location must be. If the installation
location is too small, flammable
refrigerant and air mixture will
accumulate in cases of refrigerant
leakage in cooling system. The
required space for each 8 gr of
refrigerant is 1 m3 minimum. The
amount of refrigerant in your
product is indicated on the Type
Label.
Product must not be installed in
places exposed to direct sunlight
and it must be kept away from heat
sources such as hobs, radiators,
etc.
If it is inevitable to install the product
close to a heat source, a suitable
insulation plate must be used in
between and the following minimum
distances must be kept to the heat
source:
- Minimum 30 cm away from heat
sources such as hobs, ovens, heater
units or stoves,
- Minimum 5 cm away from electric
ovens.
Protection class of your product
is Type I. Plug the product in a
grounded socket that conforms
the voltage, current and frequency
values stated on the type label of
the product. The socket must be
equipped with a 10 A – 16 A circuit
breaker. Our company shall not be
liable for any damages that will
arise when the product is used
without grounding and electrical
connection in accordance with the
local and national regulations.
Product must not be plugged in
during installation. Otherwise,
there is the risk of electric shock
and injury!
Do not plug the product in sockets
that are loose, dislocated, broken,
dirty, greasy or bear the risk of
getting in contact with water.
Route the power cable and hoses
(if any) of the product in a way that
they do not cause risk of tripping
over.
Exposing the live parts or power
cable to humidity may cause short
circuit. Therefore, do not install the
product in places such as garages
or laundry rooms where humidity
is high or water may splash. If the
refrigerator gets wet with water,
unplug it and call the authorised
service agent.
6
EN