Device Buttons; Device Leds - Televes WAVEDATAP User Manual

Table of Contents

Advertisement

WaveData

Device Buttons

7
WPS Button
This button have a double function
WPS session: press button to initiate a WPS session to authorize devices.
Push WPS on Wi-Fi STATION, too in order to complete a WPS session. WPS
session is active for a maximum of 120 seconds before become inactive.
Factory defaults: press button for at least 3 seconds to restore factory
default settings. This erase all device configuration and set device to factory
state.
Reset Button
8
Press button to hard reset device. As alternative, perform a soft reset and
perform a Reboot operation via Web or SSH command. Soft Reset is a preferred
method to reset device in a proper way and preserve settings of device.
9
MyNETWi-Fi Switch
This tri-state switch allows power of Wi-Fi radios or reduce power on air.
MyNETWi-Fi Position
Off
Wi-Fi Off
Normal
Wi-Fi Power controlled by Software (max. 22dBm)
Low
MyNETWi-Fi Mode (max. 10dBm)

Device Leds

Frontal RGB Led
Device has a frontal RGB Led to indicate device status.
LED
RBG Led Functions
Device Activity
System boot-up (kernel stage)
AP is Broadcasting SSIDs
myNETWi-Fi
Wi-Fi Off/All Vaps Disabled
System upgrade (firmware or configuration)
Device Failure
System shut-down or power Off
Switch Function
LED Pattern
Blink
Orange.
Fixed Green.
Fixed Orange.
Fixed Blue.
Blink
Blue
Fixed or
Blink
Red.
All Leds Off
Device Indicator Leds
Device has several internal led indicators:
SFP
OK
Off
Low
Normal
USB
2.4GHz Link: Blink indicates 2.4G Wi-Fi Radio is up and running. Fixed or
Off 2.4G Radio is down.
5GHz Link: Blink indicates 5G Wi-Fi Radio is up and running. Fixed or Off
5G Radio is down.
SFP OK (only in ref. 769002): indicates what is known as "LOS LEDs (SFP)".
That is, it indicates that the SFP is installed and that there is an optical
LOS: Loss Of Signal. Signal loss led. Indicates if there is a problem with
the fiber network.
ACTIVE "LOS" LED (LED in RED), if the reception of the interface (RX)
detects loss of signal (LOS). LED "LOS" will be OFF if it detects the
presence of a signal
(LINK).
Link
Link
5GHz
2.4GHz
SFP
LAN
6
WPS
R
POWER
12-24 V
max. 7W
link.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wavedatas769001769002

Table of Contents