Upgrade Firmware And Configuration - Televes WAVEDATAP User Manual

LAN zone covers LAN network.
LAN zone accepts traffic from WAN if match a active Connection or Port
Forwarding Rule. WAN zone rejects forwarding from LAN (When LAN users
start connections no State is available) so enable forwarding from LAN to
WAN in order WAN zone can accept all traffic comes from LAN.
Traffic rules
By default, Firewall is built with traffic rules to accept some traffic classes.
Following rules accept UpnP, DHCP and ping to device from WAN interfaces.
This allow configure WAN via DHCP, a ping or PlugAndPlay detection.
Another rules allows connection to web and SSH services from WAN.
Port Forwarding
Port forwarding allows propagate traffic from WAN host to a local server on
another zone. This provides visibility to local servers (LAN) on WAN network.
Following example enables port forwarding of requests from WAN zone to
router on port 15710 will be propagated to local 192.168.1.8 host. External
hosts can use router 15710 port to connect with 192.168.1.8:15710 service
hosted on LAN.

Upgrade Firmware and Configuration

Go to System>Backup/Flash Firmware. Below image shows screenshot of
upgrade interface.
Device flash operations include:
Download Backup: Save device configuration on a compressed file.
Reset to Defaults: Configure device to defaults and reboot.
Restore Backup: upgrade device configuration with a previous saved
backup.
Upgrade Firmware: Upgrade whole filesystem and kernel to latest release.
Firmware releases are provided by Televes. Check Option to keep current
settings after upgrade (checked by default).
Firmware Upgrade Firmware is performed on two-stage, first performs a
firmware validation.
After check firmware is valid, Click on Proceed to upgrade firmware.
19
EN