iNels Smart RF box eLAN-RF-003 Installation Manual page 9

Use: an eLAN-RF-003 device configured for a repeater can only be connected to the supply voltage,
and it will then function just the same as the RFRP-20. This means if it receives a command from the
RF controller or RF detector, it resends it to a designated RF element and vice-versa.

Oasis Compatible
Enables the repeater function to serve unidirectionally communicating units (RF Key, RFWB, RFIM,
detectors, etc.).

RF Touch compatible
Enables the repeater function to serve bidirectionally communicating units (RF Touch, RF Pilot, etc.).

List of addresses
Repeated address settings - write into the list of addresses those elements with which you want the
eLAN RF. If you set the eLANs to the Router mode, the same addresses must be set for both
eLANs...
After setting the function Repeater, eLAN restarts.
Router
The Router function is used to extend the distance and control of RF elements by connecting two
eLANs into the LAN network.
 The first eLAN (so-called Master) must be set during configuration in the Router function,
it receives all RF commands of controllers via an RF signal. It assess the limitations and
permissions of addresses.
 The second eLAN (so-called Slave) assess all commands from the eLAN Master
determined for sending by RF signal. It sends valid messages by RF signal to controlled
elements. If a response comes from an element, it sends it to the eLAN Master.
It is necessary to enter into the settings the LAN parameters of the second eLAN - Slave (IP address,
login data).
The second eLAN Slave can be configured in two ways.
 Active function Repeater – this receives commands via the Ethernet network and via the RF
network.
Example: eLAN Slave catches the RF signal of the RF controller, saves it as Repeater (signal
repeater), and sends the RF signal further along.
 Active function Router – eLAN is in its basic setting. eLAN only receives commands from the
Ethernet network, and ignores all RF signals.

Oasis Compatible - the sames as with the Repeater function.

RF Touch Compatible - the sames as with the Repeater function.
Manual / rev.5
eLAN-RF-003
9 of 13
Page