Inserting The Batteries In The Remote Control; Handling The Remote Control; Operating Range Of The Remote Control - Philips 65BDL3552T User Manual

65BDL3552T/75BDL3552T/86BDL3552T

2.2.1. Inserting the batteries in the remote control

The remote control is powered by two 1.5V AAA batteries.
To install or replace the batteries:
1. Press and then slide the cover to open it.
2. Insert the batteries with the correct polarity (+) and (–).
3. Replace the cover.
Caution:
Incorrect use of batteries may cause leakage or explosion. Be sure to follow the instructions below:
• Insert "AAA" batteries with the correct polarity (+ and -).
• Do not mix battery types.
• Do not use a new battery with a used one together. Otherwise, it may cause leakage or shorten the life of the batteries.
• Remove the dead batteries immediately to avoid battery leakage in the battery compartment. Do not touch exposed battery
acid, as it may cause injury to your skin.
• Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion;
leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of
flammable liquid or gas; and a battery subjected to extremely low air pressure that may result in an explosion or the leakage
of flammable liquid or gas.
NOTE: Remove the batteries from the battery compartment when not using for an extended period of time.

2.2.2. Handling the remote control

• Do not drop or apply shock to the remote control.
• Do not allow any liquid to get inside the remote control. If water has entered the remote control, wipe the remote control
with a dry cloth immediately.
• Do not place the remote control near heat and steam sources.
• Do not attempt to disassemble the remote control, unless you need to place batteries in the remote control.

2.2.3. Operating range of the remote control

Point the top front of the remote control at the remote sensor on the display when
you press the buttons.
Use the remote control within a distance of less than 5m/16ft from the display's
sensor, and a horizontal and vertical angle of less than 30°.
NOTE: The remote control may not function properly when the remote control
sensor on the display is under direct sunlight or strong illumination, or
when there is an object between the remote control and the remote
sensor of the display.
10
30 30