American Dynamics ADTT16 Operator's Manual page 35

The View button on the keypad allows you to call up the Quick Views that
you have defined for your cameras. Depending on the type of dome, either 4
or 96 Quick Views may be defined.
If a list has been compiled for your facility, you can refer to the List of Quick
Views in Appendix A to determine which Quick Views are available for
which domes.
The following procedure describes how to display a Quick View.
1. Use the number buttons to enter the number of the camera whose Quick
View you want to display, for example, camera 12. Then press the
Camera button.
2. Use the number buttons to enter the number of the Quick View you want
to display, and then press the View button.
If the Quick View exists for the selected camera, the camera will
immediately point to the pre-defined Quick View, and then zoom and
focus automatically. The following message appears on the LCD:
If you tried to call up a Quick View for a non-programmable dome, or if
you entered an invalid View number (any number greater than 96), the
T
Controlling Cameras and Their Outputs
T beeps.
OUCH RACKER
Cam 12
View
3-7