Using Other Connectors; Connecting Other Equipment Via Scart; Inserting Batteries In The Remote Control Handset; Switching The Tv On/Off - Salora LCD2631DVX Operating Instructions Manual

Using Other Connectors

You can connect a range of optional equipment
to your LCD TV. Possible connections are shown
below. Note that cables shown in the illustration are
not supplied.
• To connect external speakers, use an audio cable.
Do not reverse the AUDIO LEFT and AUDIO RIGHT
jacks. Turn on the LCD TV and external speaker set
after all connections are made. Refer to your speaker
set's manual for further queries.
• For connecting a to a device that has SPDIF support,
use an appropriate SPDIF cable to enable sound
connection. You should also set SPDIF Out option
in the Sound menu as On.
Connecting Other Equipment via
Scart
Most devices support SCART connection. You can
connect a; DVD recorder, a VCR or a decoder to your
LCD TV by using the SCART socket. Note that cables
shown in the illustration are not supplied.
Power off both the TV and the devices before making
any connections.
For more information, refer to your device's own
instruction book.
03_MB25_[GB]_(01-TV)_COST_1900UK_IDTV_BRONZE9_26883W_10064216.indd 85 03_MB25_[GB]_(01-TV)_COST_1900UK_IDTV_BRONZE9_26883W_10064216.indd 85
Inserting Batteries in the Remote
Control Handset
• Remove the battery cover located on the back of
the handset by gently pulling backwards from the
indicated part.
• Insert two AAA/R3 or equivalent type batteries
inside. Place the batteries in the right directions and
replace the battery cover.
Note : Remove the battery from remote control
handset when it is not to be used for a long period.
Otherwise it can be damaged due to any leakage of
batteries.
Remote range is approximately 7m/23ft.

Switching the TV On/Off

To Switch the TV On

• Connect the power cord to the 220-240V AC 50 Hz.
Then the standby LED lights up.
• To switch on the TV from standby mode either:
• Press the " " button, P+ / P- or a numeric button
on the remote control.
• Press the STANDBY button, -P/CH or P/CH+ button
on the TV. The TV will then switch on.
Note : If you switch on your TV via PROGRAMME
UP/DOWN buttons on the remote control or on the
TV set, the programme that you were watching last
will be reselected.
By either method the TV will switch on.

To Switch the TV Off

• Press the " " button on the remote control or press
the STANDBY switch on the TV, so the TV will switch
to standby mode.
• To power down the TV completely, unplug the
power cord from the mains socket.
English - 85 -
31.08.2009 13:16:43 31.08.2009 13:16:43