Connecting The Intellex To A Network; Rack Mounting The System; Ensuring Proper Rack Mounting - American Dynamics Intellex Intellex Ultra Installation And Configuration Manual

Installing Hardware
Pin No.
4
G
5
G
6
G
7
G
8
G
16
G
18
G

Connecting the Intellex to a Network

Only connect the Intellex to a network if you have installed the Network Client, Browser Client, or
other software designed to connect to an Intellex on the network. Use shielded twisted-pair cable
for network operation.
Connect the cable from the local area network to the Ethernet 10/100 port. Use Category 5
twisted-pair Ethernet cable (CAT 5 TPE).

Rack Mounting the System

The Intellex rack-mounting chassis has pre-drilled holes to install the included rack slides. Mount
the unit by attaching rack slides to the chassis and using the included front mount rack holes.

Ensuring Proper Rack Mounting

Consult with the supplier of your equipment rack for adequate rack mounting for the unit's weight,
for the proper hardware, and for the procedure for mounting this product safely and usably. Avoid
uneven loading or mechanical instability.
Caution
You must mount the unit in a fully supported rack. Use rails rated for a minimum of 150 pounds that
attach to both sides of the unit and to the front and back of the rack. The rack must be equipped with EIA-
310-D standard 19-inch front and rear mounting flanges.
14
Alarms In
Assignment
Input 4
Ground
Input 5
Ground
Input 6
Ground
Input 7
Ground
Input 8
Ground
Time sync signal
Ground
Export signal
Ground
Alarms Out
Pin No. Assignment
4 Output 4
G Ground
5 Output 5
G Ground
6 Output 6
G Ground
7 Output 7
G Ground
8 Output 8
G Ground
16 Output 16 (Unit Alarm) Out
G Ground
COM Reserved
NO Reserved
Intellex® Ultra