Advertisement
Problem
There is water on the
floor.
You cannot open the
appliance door.
The appliance makes an
unusual noise.
The appliance fills with
water and drain immedi-
ately.
The washing results are
not satisfactory.
After the check, activate the appliance. The
programme continues from the point of inter-
ruption.
If the problem occurs again, contact the Serv-
ice.
Service
We recommend the use of original spare parts.
Technical information
Dimensions
Electrical connection:
Level of protection against ingress of solid particles and moisture en-
sured by the protective cover, except where the low voltage equip-
ment has no protection against moisture
14
Set the drain programme if you set an option which ends with water in the drum.
If above mentioned solutions do not help, contact the Service (as the filter of the
drain pump may be clogged).
Make sure that the couplings of the water hoses are tight and there are no water
leakages.
Make sure that the water inlet hose and the water drain hose has no damages.
Make sure you use the correct detergent and the correct quantity of it.
Make sure that the washing programme is finished.
Set the drain or the spin programme if there is water in the drum.
Make sure that the leveling of the appliance is correct. Refer to 'Installation in-
struction'.
Make sure that the packaging and/or the transit bolts are removed. Refer to 'Instal-
lation instruction'.
Add more laundry in the drum. The load may be too small.
Make sure that the drain hose is in the correct position. The end of the hose may
be is too low. Refer to 'Installation instruction'.
Increase the detergent quantity or use a different detergent.
Use special products to remove the stubborn stains before you wash the laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
Width / Height / Depth
Total depth
Voltage
Overall power
Fuse
Frequency
Possible solution
When contacting the Service, make sure that
these data are available. You can find the infor-
mation on the rating plate: model (Mod.), PNC
(Prod.No.), Serial number (Ser.No.).
600 / 850 / 452 mm
502 mm
230 V
2100 W
10 A
50 Hz
IPX4
www.zanussi.com
Advertisement
