Service And Maintenance - Hunter TTS-800 Series Owner's Manual

Service and Maintenance

Rotor Assembly Removal
and Installation
1. Use the snap ring removal tool
(P/N 251000SP) or a flathead
screwdriver to turn the selector
switch to the OFF position.
WARNING: Ensure the selector
switch is in the OFF position before
removing the internal riser assembly.
NOTE: Notice that the selector
switch is raised above the lid surface
when in the manual OFF position.
8
Page
|
GOLF IRRIGATION Built on Innovation
2. Insert the end of of the snap ring removal
tool into the slot in the snap ring and pull
up to remove the snap ring.
®
3. Insert the end of the snap ring removal
tool into the slot in the riser logo cap and
turn to engage. Then pull up to remove
the internal riser assembly.