Connecting Devices - D-Link DWR-926 Quick Installation Manual

Connecting Devices

After the DWR-926 has been successfully installed, the router can
be connected to the end device via the following connection
methods:
Over Ethernet
The Ethernet port can be connected to an end device. Use a
standard Category 5/5e/6 RJ-45 Ethernet cable to connect the
end device to the router. The port will auto-negotiate to the
highest possible port speed based on the connected device.
Note that the DWR-926 supports a maximum transfer speed of
300 Mbps over Ethernet.
Over Wi-Fi
You can connect to the router using the SSID and security
settings listed on the bottom of the router. If your Wi-Fi has
previously been configured, use those settings instead. The
router supports up to 802.11n/ac speeds on the 2.4GHz/5GHz
network. Maximum tranfer speeds are dependent on network
conditions.
9
DWR-926