Table of Contents
Advertisement
Available languages
Available languages
USE
1. Set the base on a flat, stable and heat-resistant surface that is not
exposed to splashes of water or any heat source.
2. Opening the lid
• Grasp the teapot handle and remove the lid with the basket
2/3). Do not operate the tea maker without its lid. If the lid is lost or
broken, please contact your After-Sales service centre.
• The tea maker must only be used with the base provided.
3. Fill the teapot with the desired quantity of water
• Never fill the teapot when it is sitting on its base.
• Do not fill it above the maximum level, or below the minimum level. If
it is not filled to the minimum level, temperature accuracy cannot be
reached (temperature accuracy +/- 3°C).
• If the teapot is too full, boiling water may spill out. Do not operate the
tea maker without water. Check that the lid is properly closed before
use.
• Do not put the infuser basket back in the teapot.
4. Set the teapot on its base and REPLACE THE LID (diagram 5).
Connect the tea maker power cable.
• the base will light up and indicate the water temperature in real time.
(diagram 5+ zoom)
5. Starting the tea maker
A. Temperature selection
– Press the temperature selection button
temperature: 40°C, 50°C, 60°C, 70°C, 80°C, 85°C, 90°C or 100°C.
– The temperature selection indicator light flashes 4 times and beeps,
and heating begins (diagram 7).
– Note: It is possible to start the cycle before the automatic start by
pressing the on/off button.
– When the required temperature is reached, the tea maker stops and
beeps twice
B. Tea infusion
– Without removing the teapot from its base, remove the lid from the
infuser basket
– Fill the infuser basket with the desired quantity of tea leave or tea
bag(s)
(diagram 10)
– Replace the infuser basket in the teapot, taking care not to burn
yourself by touching the lid
10
(diagram 8).
(diagram 9)
(diagram 11).
(diagram 4)
(diagram
6), select the
(diagram
Advertisement
Table of Contents
