Table of Contents
Advertisement
INITIAL SET UP
HARNESS SET UP – INITIAL PERSONAL ADJUSTMENT
Your HYDROS PRO features a highly-adjustable, alpine-style harness. To get the best
results, you should fine tune your HYDROS PRO to suit your body type and size:
1. WAIST STRAP ADJUSTMENT
a. Put the BC on, place the waist strap low on your waist, fasten the waist buckle and then
tighten the strap until snug by pulling the plastic D-ring to your left.
b. If the strap is too SHORT:
i. There is an extra length of webbing stowed in the right hand waist pad.
ii. Pull some of the spare webbing out and reposition the right side (female) buckle on
the webbing so that it increases the effective length of the waist strap.
24
INITIAL SET UP
c. If the strap is too LONG:
i. The waist pads can be adjusted to be closer to the backpack, thus shortening the
effective length of the waist strap.
ii. Release and remove the grey plastic snap-clip that secures the waist webbing to
the back pack.
iii. Pull more waist webbing through the slot in the back pack so that the next adjustment
position is exposed.
iv. Replace the plastic snap-clip by sliding it through the loop in the webbing and the
snapping it closed.
v. Ensure you adjust both sides evenly so that the BC fits you symmetrically.
25
Hide quick links:
Advertisement
Table of Contents
