Initial Setup; Getting Started - Uwatec HYDROS PRO User Manual

GETTING STARTED

INITIAL SET UP
SYSTEM SET UP - SELECT WEIGHT SYSTEM OR TRAVEL SYSTEM
Your HYDROS PRO is actually 2 BCs in 1! It is supplied with two different Waist Strap
systems that enable you to configure the BC for your exact type of diving and to quickly
and easily change between the two systems as your diving environment changes.
System 1 is a full weight integrated system that uses our patented Buckle Weight System.
System 2 is a minimalist, Travel waist strap similar to what Technical divers use.
TO CHANGE FROM ONE SYSTEM TO THE OTHER:
a. Disconnect the shoulder strap quick-release buckles.
b. Release and remove the grey plastic snap-clip that secures the waist webbing to the
backpack.
c. Pull the waist strap you are removing away from the BC, the webbing will pull out of the
slot on the backpack.
d. Thread the back end of the waist webbing (from the system you want to add) through
the slot on the backpack, passing from the front (diver side) to the rear (cylinder side)
and without trying to pass through the opening in the soft Lumbar Pad.
e. Replace the plastic snap-clip by sliding it through the loop in the webbing and then
snapping it closed.
f. Re-connect the shoulder strap buckles.
21