Table of Contents
Advertisement
5.3.3
Power-on LED CR3 (JP6)
The power-on LED, CR3 can be disconnected by removing JP6, typically used for current consumption
measurements (see chapter 5.3.2 Current Consumption Measure (JP5)).
5.3.4
Power Supply For External Application Board (JP7)
An external application board can be directly power supplied from the XE1401SK. The power source selection for
pin 48 (VOUT) of the 50 pins connector JP2 is selected by JP7.
© Semtech 2006
17
Users Guide
XE1401SK Hardware
www.semtech.com
Advertisement
Table of Contents
