Aqua Lung GripLock 428230 Installation

3
Push the lever forward until it stops in the pre-locked position (this
keeps you fingers from being caught in lever) (Fig. 10). Push the lever
down into the locked position. Verify the lever is secured in the locked
position (Fig. 11). Once the cylinder band is set up, further adjustment is
typically not needed.
Figure 10
4
Check the cylinder band is secure by pulling on the band while holding
down the cylinder at the valve. If the cylinder band moves, it is too loose.
Check the macro adjustment is set for the correct size cylinder. Repeat steps
1-4 of Securing the GripLock™ Cylinder Band to tighten and secure the
cylinder band.
WARNING: Verify the tension of the cylinder band prior to every dive. Failure to do
so may result in the cylinder tension slipping during the course of a dive.
If you have any questions regarding the GripLock™ cylinder band or the
information found in this manual, please contact your regional Aqua Lung
Dealer or Distributor. Distributor information is available on the Aqua Lung
website at: www.aqualung.com
Figure 11
1
the right BC slot (Fig. 1 & 2).
Rev. 11/12
GRIPLOCK™ CYLINDER BAND
428230 - Wrapture Version
428210 - Non-Wrapture Version
Installation of GripLock™ Cylinder Band
READ ALL INSTRUCTIONS PRIOR TO ASSEMBLY
NOTE: Before removing the original cylinder band, examine how it is woven through the
BC. It is critical to weave the GripLock™ cylinder band in the same fashion.
GripLock™ Components
MICRO
ADJUSTMENT BAIL
Threading the GripLock™ Cylinder Band
Remove the bail from the cylinder band. Insert the open end of the
cylinder band through the left slot in the BC, weave it through and out
Figure 1
BAIL
LEVER SLOT
MACRO
ADJUSTMENT
Figure 2