Connection And Pre-Heating - TEFAL KALITIS 2195 Manual

Thank you for buying this TEFAL
appliance, which is intended for
domestic use only. Read the instructions
in this leaflet carefully and keep them
within reach. They apply to every
version depending on the accessories
that come with your appliance (NB:
parts (A – 1) and (A/D – 8) are only
included with certain models).
TEFAL has an ongoing policy of research and
development and may modify these products without
prior notice.
The drawings shown on page 2/3 illustrate
the instructions.
Assembly
Before first use:
• Remove any packaging, stickers or
accessories inside and outside the
appliance.
* A/D: N.B. For models with a splatter
guard (1) and support legs (8): these parts
come packed between the reflector (6)
and the base of the appliance (7). Make
sure that you remove them before
connecting the appliance to the electricity
supply.
• G: Firmly insert both lid supports (9) at
the rear of the appliance (only for the
Masteris model).
• A/D: Assemble the support legs (8)
(depending on model) with the help of the
assembly leaflet delivered inside the bag
of the accessories.
• A/D: Clean the grill plate (3) and the
protection lid (2) (depending on model) :
follow the instructions in the paragraph
"After use".
ENG
A/D: Place the reflector (6) in the base of
the appliance (7): the curved part of the
reflector (6a) must be positioned towards
the front.
B/E: Place the heating element (4) on the
reflector (6) then press firmly on the control
panel (5) to position it in the housing
provided for this purpose, so that the safety
system is activated.
32
C/F: If the heating element is
incorrectly positioned, the safety
system will prevent the appliance
from working.
A/D: Pour 1.5 litre maximum of water into
the reflector (6) so that
the appliance works.
A/D: Place the grill plate (3) on the
appliance.
* Depending on model :
• A/D: Insert the support legs (8) inside the
legs integrated in the body of the appliance.
• A: Place the splatter guard (1) on the grill
plate (3) and insert it into notches of the
grill plate.
• H: Place the protection lid (2) inside the
lid supports (9) situated at the rear of the
appliance.
Connection
and pre-heating
A/D: If your appliance is not equipped with
support legs (8), place it on a firm heat
resistant surface.
Do not use it on a flexible type of support,
such as a rubberised protective cloth.
Never place the appliance directly onto a
fragile surface (glass table, cloth,
varnished furniture...).
To avoid overheating of the appliance, we
recommend you do not place it in a corner
or against a wall.
Unwind the cord completely.
Check that your electric installation is
compatible with the power and the voltage
indicated under the appliance.
Connect the appliance to a socket with an
earth connection.
Supply the appliance through a residual
current device (RCD) having a tripping
current not exceeding 30 mA.