Ingersoll-Rand 341 Series Maintenance Information
Air percussive tamper
Hide thumbs
Also See for 341 Series:
- Operation and maintenance manual (20 pages) ,
- Product information (56 pages)
Related Manuals for Ingersoll-Rand 341 Series
Summary of Contents for Ingersoll-Rand 341 Series
- Page 1 16600421 Edition 2 May 2014 Air Percussive Tamper 341 and 441 Series Maintenance Information Save These Instructions...
-
Page 2: Product Safety Information
Product Safety Information WARNING Failure to observe the following warnings, and to avoid these potentially hazardous situations, could result in death or serious • injury. • Read and understand this and all other supplied manuals before installing, operating, repairing, maintaining, changing accessories on, or working near this product. - Page 3 Assembly General Instructions Always clean every part and wipe every part with a thin film of oil before installation. Whenever grasping a tool or part in a vise, always use leather- Apply a film of O-ring lubricant to all O-rings before final covered or copper-covered vise jaws.
-
Page 4: Troubleshooting Guide
Troubleshooting Guide Trouble Probable Cause Solution Sluggish operation Dirt or oil gum accumulation on internal Pour about 3 cc of a clean, suitable, cleaning parts solution into the air inlet and operate for 30 seconds. After flushing, pour about 3 cc of oil into the air inlet and operate the tool for 5 seconds to coat the internal parts with oil. - Page 5 Notes:...
- Page 6 Notes:...
- Page 7 Notes:...
- Page 8 ingersollrandproducts.com © 2014 Ingersoll Rand...
Need help?
Do you have a question about the 341 Series and is the answer not in the manual?
Questions and answers