Troubleshooting, Maintenance And Product Classification; Specifications And Adjustments; Troubleshooting Guide; Maintenance - Amico Hummingbird Lite Installation Instructions Manual

Troubleshooting, Maintenance, Product Classification

Specifications and Adjustments

Refer to Amico website for the manual and specification documents.

Troubleshooting Guide

Problem
LCD/Display mount facing wrong
direction
Loosened worktop
Sliding Keyboard Tray falls off
Laptop adjustable clamp is not opening
Too easy or too difficult to utilize the
portrait landscape feature
The LCD/Display mount is not secure,
it is wobbling or loose when using the
portrait landscape feature
LCD/Display drifts down

Maintenance

Area
VESA 75/100 Adapter Check if the VESA Plate and LCD/Display are securely attached. Ensure the four screws on
(FIT Units only) the Mounting Plate(s) are fastened to the tightest possible position.
Visually inspect for any signs of grinding and gapping.
LCD/Display Post Inspect bolt, washers and contacting surfaces for grinding and wearing. Ensure bolt is
tightened (using 5/32" ball end hex key) Located bottom center of the post.
Casters Inspect Casters for debris, chipping and ensure that all Casters are making contact with
the floor.
Ensure the Locking Mechanisms on Directionally Locking and Total Locking Casters are
functioning correctly (test by pressing down with foot and attempting to move the cart).
Manual Height Check if the height adjustment is smooth.
Adjustable Column
Handle Ensure that the Handle screws are tight, if loose then tighten using #3 Philips screw
driver (Screws are underneath the worktop).
General Clean any dust build-up on the cart and vacuum the dust out around the wheels.
It is recommended that all locks, bolts and screws are visually inspected for signs of
product wear and tear or damage. Check the product for looseness in the mount.
Possible Cause
Incorrect installation
Improper installation or loose
connection
Forgot to install the stopper
Missing key
Damaged hardware
Damaged LCD/Display mount
Incorrect gas spring in LCD/Display Post
Maintenance
Solution
Check the LCD/Display Post hole positions,
should keep the LCD/Display mounting
facing front with 180° hole pattern
Check the screws between worktop and
column plate, should be tightly secured
Make sure always stopper is installed
Locate the key or contact Amico
Please contact Amico Accessories
LCD/Display mount needs to be replaced.
Please contact Amico Accessories
Please contact Amico Accessories
www.amico.com 21
Period
(Month)
3
1
1
1
3
3
3
1
3