Ingersoll-Rand 61H Series Maintenance Information
Air grinder
Hide thumbs
Also See for 61H Series:
- Product information (80 pages) ,
- Product information (44 pages) ,
- Product information (8 pages)
Related Manuals for Ingersoll-Rand 61H Series
Summary of Contents for Ingersoll-Rand 61H Series
- Page 1 16573321 Edition 3 February 2014 Air Grinder Series 61H Maintenance Information Save These Instructions...
- Page 2 Product Safety Information WARNING • Failure to observe the following warnings, and to avoid these potentially hazardous situations, could result in death or serious injury. • Read and understand this and all other supplied manuals before installing, operating, repairing, maintaining, changing accessories on, or working near this product.
- Page 3 9. Pull the Front Rotor Bearing (29), Rotor Spacer Assembly (27) and 3. To remove the Throttle Lever Assembly (13), press the Throttle Front End Plate Assembly (25) off the hub of the Rotor. If the Seal Lever Pin (11) out of the throttle handle. Cup Assembly (28) must be replaced, pull the Assembly off the 4.
- Page 4 7. Slide the Exhaust Deflector onto the Arbor Housing and, using a thin blade screwdriver, spiral the Deflector Retaining Ring (37) into the groove ahead of the Deflector. Apply Adhesives 8. Using finger pressure, press the Seal Cup Assembly (38), felt end at the indicated trailing, onto the small end of the Bearing Nut Assembly (31) until places...
- Page 5 d. Thread the Cone Wheel Adapter or Collet Body onto the Arbor g. Thread the Wheel End Bearing Cap into the Arbor Housing and tighten it between 14 and 19 ft-lb (19 and 26 Nm) torque. and tighten it between 40 and 50 ft-lb (54 and 68 Nm) torque. e.
- Page 6 15. Thread the Throttle Handle Assembly into the assembled Arbor 17. After assembling the tool, test the Grinder. If the Controller Housing and tighten the joint between 74 and 100 ft-lb (100 and length “B” and nozzle face length “C” were within tolerance and 135 Nm) torque.
- Page 7 Notes:...
- Page 8 ingersollrandproducts.com © 2014 Ingersoll Rand...
Need help?
Do you have a question about the 61H Series and is the answer not in the manual?
Questions and answers