Breville Dual Disc Juice Processor BJE820XL Instruction Booklet page 32

TROUBLESHOOTING
POSSIBLE PROBLEM
Juicer suddenly
switches off during
juicing
Red light flashing
32
EASY SOLUTION
• The juicer has been stressed by overloading
or stalling. Juicer will automatically activate the
overload protection button and the unit will switch
itself off. When this happens it is recommended
that the unit is switched off at the power outlet
and unplugged. Then press the Overload
Protection Button found on the bottom of the
Motor Base. The safety device will then be reset
and the Breville Juice Processor is ready for
use again.
• This may indicate that the motor has been stress
by Overheating with excessive load. The Juicer
is fitted with a self-resetting safety device which
safeguards against overheating on the motor
with excessive loads. If overheating occurs, the
juicer will automatically activate the overheating
protection device and the motor will switch itself
off. When the overheating protection is activated,
unplug the juicer from power outlet for at least
15 minutes to allow the unit to cool. Then plug
juicer into the power outlet and use as normal.
• The Juicer will automatically stop operating
if the motor is stalled. If this occurs, the light
surrounding the Start/Stop button will flash red.
This is an electronic safety feature. Either too
much food is being processed at one time or the
pieces are not small enough. Try trimming food,
cutting food into smaller pieces of even size and/
or processing a smaller amount per batch. To
continue juicing, unplug the juicer from power
outlet, reset the Juicer by pressing the Start/Stop
button to "Off", then clear the feed chute, finally
turn the appliance back on by pressing the Start/
Stop button to "ON".