Alpine DVA-9965 Owner's Manual page 64

Picture is unclear or noisy.
• Disc is being fast-forwarded or fast-reversed.
- The picture may be unclear, but this is normal.
• Vehicle's battery power is weak.
- Check the battery power and wiring.
(The unit may malfunction if the battery power is under 11
volts with a load applied.)
• Monitor's fluorescent tube is worn out.
- Replace the monitor's fluorescent tube.
Image stops sometimes.
• Disc is scratched.
- Replace with a non-scratched disc.
Indication for CD Player
HI TEMP
• Protective circuit is activated due to high temperature.
- The indicaton will disappear when the temperature returns to
normal operating range.
NO DISC
• No CD is inserted.
- Insert a CD.
• Although a disc is inserted, "NO DISC" is displayed and the
unit does not start to play or eject the disc.
- Remove the disc by following these steps:
Press the c button again for at least 2 seconds.
If the disc still does not eject, consult your Alpine dealer.
ERROR
• Mechanism error.
1) Press the c button and eject the CD.
If not ejecting, consult your Alpine dealer.
2) When the error indication remains after ejecting, press the
c button again.
If the error indication still does not turn off after pressing
the c button for a few times, consult your Alpine dealer.
• When "ERROR" is displayed:
If that the disc cannot be ejected by pressing c, press the RESET
switch (refer to page 8) and press c again.
If the disc still cannot be ejected, consult your Alpine dealer.
PROTECT
• A copy-protected WMA file was played back.
- You can only play back non-copy-protected files.
UNSUPPORT
• The disc is not written in a MP3/WMA supported format.
- Use a disc written at the MP3/WMA supported format.
62
-EN
Indication for DVD/Video CD Player
DISC ERROR
(Monitor display)
• Mechanism error.
1) Press c and eject the disc.
If the disc does not eject, press c again for at least 2
seconds and eject the disc.
If the disc still does not eject, consult your Alpine dealer.
2) When the error indication remains after ejecting, press c
again.
If the error indication still does not turn off after pressing
c a few times, consult your Alpine dealer.
NO DISC
(Monitor display)
• No disc is inserted.
- Insert a disc.
• Although a disc is inserted, "NO DISC" is displayed and the
unit does not start to play or eject the disc.
- Remove the disc by following step:
Press c again for at least 2 seconds.
(Monitor display)
• Remote control operation is not possible.
- For some discs or playing modes, certain operations are not
possible. This is not a malfunction.
REGIONAL CODE
VIOLATION
(Monitor display)
• Disc does not match regional code number.
- Load a disc that matches the regional code number.
HI-TEMP
(Monitor display)
• Protective circuit is activated at high temperature.
- The indicaton will disappear when the temperature returns to
normal operating range.
- Leave the power OFF until the temperature decreases and
then turn the power ON again.
ERROR
(Audio display)
NO DISC
(Audio display)
ERROR
(Audio display)
HI TEMP
(Audio display)