HP 9000 200 Series Manual page 76

11. Press
I
PAUSE
1
(~
on an ITF keyboard) and then type
EDIT
and press
I
Return
I.
The display on the CRT changes to show the program. The line you were editing
last appears in the current-line position. Notice that the run light is still visible in
the lower right-hand corner and it indicates that the program is paused.
User 2 Caps Paused
1---
"Program-Status" Indicator
I---"Run Light"
12. Press
I
CONTINUE
1
(@] on an ITF keyboard). The CRT returns to normal mode,
and the printout of numbers continues in sequence. However, the previous data on
the display was lost when the CRT was used for EDIT mode.
System Caps Running
1---
"Program-Status" Indicator
,---"Run Light"
13. Press
I
PAUSE
1 (~
on an ITF keyboard). Then type
EDIT
50
and press
I
Return
I.
The CRT changes to EDIT mode and the program appears again. This time, line 50
is in the current-line position. Notice that the run light indicates that the program
is paused. Change line 50 to
WAIT
.2
and press
I
Return
I.
The new line 50 is entered,
but the run light changes. Editing the program caused it to move from the paused
state to the stopped state.
User 2 Caps Idle
- - - "Program-Status" Indicator
1---
No "Run Light"
Loading and Running Programs
4-13