Advertisement
III.
APANTEC SCALER CARDS
The output resolution and settings for the Apantac cards can be adjusted through the Ross
Dashboard interface which is loaded on the system laptop PC.
The cards can accept single link DVI, HDMI (with adapter) and VGA analog (with adapter)
signals. The input is default for HDMI input with 1080i as the HD-SDI output signal.
Genlock for these cards is provided through the Ross OpenGear frame which is referenced to
the Ross TSG.
IV.
TALLY
Eight tallies from the Panasonic switcher
are available on the patch panel. Refer to
the Panasonic HS-6000 User Guide on how
to assign tallies to cross-points.
DO NOT use both the XLR and terminal
post connectors at the same time. Pick
one or the other for tally connection.
V.
POWER
The rack has a single 120V input line. Amp draw for the system is 2-3 amps.
There are no redundant power supplies for any of the components.
VI.
TOUCH SCREEN GUI FOR SWITCHER
[TYPE HERE]
The GUI stores in the second drawer of the system.
The Vesa plate and DVI inter-connect cable stay
attached to the back of the monitor.
DO NOT CONNECT THE MONITOR TO THE SWITCHER
WITH THE POWER ON.
Make sure the control power is off when attaching
the DVI.
[TYPE HERE]
3
[TYPE HERE]
Advertisement
