Charging The Battery; Power Connection; Battery Charging Time; Battery Talk & Standby Times - Audiovox CDM-8500 User Manual

Tri mode digital cdma2000 1xrtt handheld portable telephone
Hide thumbs Also See for CDM-8500:
Table of Contents

Advertisement

CHARGING THE BA
CHARGING THE BA

POWER CONNECTION

Connect the charger to a standard 110V AC outlet. The
battery can be charged alone, or when attached to the
phone.

CHARGING THE BATTERY

The battery can only be charged when attached to the phone.
The LED will indicate charging status.
G Red indicates charging is in progress.
G Green indicates charging is complete.
NOTE:
1. The battery is not charged at the time of
purchase.
2. Fully charge the battery before use.
Page 14 - Chapter 1
TTER
Y
CHARGING THE BA
TTER
Y
CHARGING THE BA
NOTE:
1. It is more efficient to charge the battery with
2. The battery must be connected to the phone in
3. If the LED flickers while charging, the battery
4. Once fully charged, the LED may change from
5. Battery operating time gradually decreases over
6. If the battery fails to perform normally, you may

BATTERY CHARGING TIME

Battery Type
Charging Time
NOTE:
Charging time applies only when your phone is
turned off. Charging time may vary if your phone
is turned on.
BATTERY TALK & STANDBY TIMES
Status
Talk (min)
Standby (hrs)
NOTE: These times are for a new battery. Talk and
standby time may decrease over time.
TTER
TTER
the handset off.
order to charge.
contacts may need cleaning.
red to green. This does not indicate a
problem with the battery.
time.
need to replace the battery.
BTR-
BTE-
(900mAh)
(900mAh)
minutes
minutes
Type
PCS
CDMA
AMPS
157
150
113
103
Chapter 1 - Page 15
Y
Y
103
25

Advertisement

Table of Contents
loading

Table of Contents