Lubrication - MAULE Orion M-7-260C Maintenance Manual

10. RUDDER TAB:
This tab is interconnected with the aileron system to automatically coordinate aileron and
rudder controls for simplified handling in the air. (It may be used as a rudder trim tab to make
the airplane trim in cruise.) This tab may be adjusted by changing to the position of the tab
cables where they attach to the aileron cables located just over the front doors on the inside of
the airplane. Normally, the tab should be streamlined with the rudder when the aileron and
rudder controls are centered, using the centering spring for rigging adjustments (See 7
above).
The tab travel is 48° ±4° right or left. Proper cable tension is 5 to 10 lbs.
CAUTION: Make sure tab is free at extreme aileron travel.
NOTE: The "Rudder Trim Control" on the instrument panel pulls on a spring attached to the
right rudder pedal. It is not connected to the tab on the rudder.
1. Main wheel bearings - Use aircraft quality bearing grease.
2. Hydraulic brake reservoirs - Use Texaco Aircraft Hydraulic Oil 15 conforming to MIL-H-5606E,
or equivalent.
3. Control Column - Apply light coat of graphite base lubricant to aileron balance chain, torque
tube and control guide. Use lightweight motor oil or LPS #2* on all other bearings.
4. Control pulley bearings and control surface hinges - Use lightweight motor oil or LPS 2*.
5. Flap bellcrank and mechanism - Use lightweight motor oil or LPS 2*.
6. Aileron and flap hinge - Use lightweight motor oil or LPS 2*.
7. Elevator and trim tab - Use lightweight motor oil or LPS 2*.
8. Tailwheel - Good quality wheel bearing grease to tailwheel bearings through zerk fitting.
Same for fork spindle roller bearings, if necessary. See tailwheel maintenance section under
"Landing Gear, Wheels and Brakes".
*LPS 3 recommended for airplanes operating in a potentially corrosive environment.
Rev. C
MAULE AEROSPACE TECHNOLOGY, INC.
MAINTENANCE MANUAL
M-7-260C
FOR

LUBRICATION

19/37