Nordpeis S-18 F User Manual page 13

Reload size
Chopped wood - 2 logs (diametre of 6-9cm)
Length: 25-30cm
Normal load size. 1,07 kg /h
(Max load size: 1,5 kg/h)
Attention!
Using the insert with low combustion effect and firing
around the clock increase pollution as well as the risk
for a fire in the chimney. Never allow the insert or flue to
become glowing red. Turn off the air vent control should
this happen. Regulation of the air vent control takes
some experience, but after a little while a natural rhythm
for the fire will be found.
IMPORTANT! Always remember to open
the air vent control before new wood logs are inser-
ted into a hot burn chamber. Let the flames get a
good grip on the wood before the air control setting
is reduced.
When the draught in the chimney is low and
the vent is closed, the gas from the firewood
can be ignited with a bang. This can cause
damage to the product as well as the immediate
environment.
6. Maintenance
Cleaning and inspection
The insert should be inspected thoroughly and clened
at least once per season (possibly in combination with
the sweeping of the chimney and chimney pipes).
How to get access to soot after a chimney sweep see
drawing FIG 8 and FIG 11.
Ensure that all joints are tight and that the gaskets are
rightly positioned. Exchange any gaskets that are worn
or deformed.
Remember that the insert must always be cold when
inspected. The inspection shall be performed by the
Professional servicemen.
Ashes
The ashes should be removed at regular intervals.
Be aware that the ashes can contain hot ember even
several days after the fire is finished. Use a container
of non-combustible material to remove the ashes. It is
recommended to leave a layer of ashes in the bottom
as this further insulates the burn chamber.
Take care with the Thermotte plates when the ashes are
removed, particularly when using an ash shovel, so as
not to damage them.
Thermotte™ insulating plates
The insulation plates (Thermotte -
as "wear and tear" parts which will require to be
exchanged after some years. The wear time will
depend on the individual use of your product. Nordpeis
offers a one-year warranty on these parts. After this,
replacements can be purchased.
If new plates are needed, contact your dealer.
FIG 2) are classified
GB
The assembly of the thermotte plates is done in
following order:
A. Bottom plate + front plate
B. Back plate
C. Smoke bafle
D. Side plate left
E. Side plate right
See also drawings from FIG 8 to FIG
Please note: Wood logs that are too long can cause
additional strain and crack the plates, due to the tension
created between the side plates.
Door and Glass
Should there be any soot on the glass it may be
necessary to clean it. Use dedicated glass cleaner, as
other detergents may damage the glass.
(Attention! Be careful, even dedicated glass cleaner
can damage the varnish on the door frame and the
gaskets). A good advice for cleaning the glass is to
use a damp cloth or kitchen roll paper and apply some
ash from the burn chamber. Rub around the ash on
the glass and finish off with a piece of clean and damp
kitchen roll paper.
Attention! Only clean when the glass is cold.
Check regularly that the transition between the glass
and the door is completely tight.
Periodically, it may be necessary to change the gaskets
on the door to ensure that the burn chamber is air tight
and working optimally. These gaskets can be bought as
a set, usually including ceramic glue.
CERAMIC GLASS
CANNOT BE
RECYCLED
Ceramic glass should
be disposed of as resid-
ual waste, together with
pottery and porcelain
Recycling of ceramic glass
Ceramic glass cannot be recycled. Old glass, breakage
or otherwise unusable ceramic glass must be discarded
as residual waste. Ceramic glass has a higher melting
temperature, and can therefore not be recycled together
with glass. If mixed with ordinary glass, it would
damage the raw material and could, in worst case end
the recycling of glass. It is an important contribution to
the environment to ensure that ceramic glass does not
end up with the recycling of ordinary glass.
Packaging Recycle
The packaging accompanying the product should be
recycled according to national regulations.
12.
13