Beaba 920290 Instructions Manual page 9

IMPORTANT: KEEP FOR FUTURE REFERENCE NEEDS.
READ CAREFULLY
CAUTION: "NEVER LEAVE A CHILD UNSUPERVISED"
• Check that the surface is stable before laying the child on it.
• Be aware of the dangers of naked flames and other intense sources of
heat, such as electric element heaters, gas heating, etc.... when they are
close to the changing equipment.
• All fastening parts must always be installed correctly and checked regularly.
• Never leave small parts within a child's reach.
• Always position the changing table at the centre of the bath or the bed.
• Before using, check that the changing table is stable by pressing down on
the front section. It must not tilt or lift.
• To be assembled by an adult.
• Never place the product above chest height.
• Cleaning and maintenance: use a sponge and slightly soapy water.
• Maximum age of usage :12 months old / Maximum weight: 11kg
• Never use any other additional parts or spare parts other than those
supplied by your shop or recommended by Beaba.
• Never use the changing table if a part is broken, twisted, or missing.
e
2. Position the suction caps with plastic rings (d) in the upper or lower rails
(g) depending on the dimensions of your bath. Place the suction cap in
the largest upper hole and slide it along.
g
d
1. Place the suction cap(s) (e) in the
casings (f) situated at the rear of
e
the changing table (a)
g
d
9