Summary of Contents for National Instruments NI TB-2708
Page 1
(217) 352-9330 | Click HERE Find the National Instruments TB-2708 at our website:...
Page 2
PXI Terminal Block for S Series Devices This installation guide describes how to install and connect signals to the NI TB-2708 terminal block for use with PXI-6115/6120 S Series devices. The connectors of the TB-2708 are sensitive to electrostatic discharge (ESD). The...
If the device is damaged, turn the device off and do not use it until service-trained personnel can check its safety. If necessary, return the device to National Instruments for service and repair to ensure that its safety is not compromised.
Do not substitute parts or modify equipment. Because of the danger of introducing additional hazards, do not install unauthorized parts or modify the device. Return the device to National Instruments for service and repair to ensure that its safety features are not compromised.
Figure 3 shows the front panel of the TB-2708, and Figure 4 shows the TB-2708 block diagram. Refer to Table 1 for a brief description of each signal available on the TB-2708. Figure 3. NI TB-2708 Front Panel NI TB-2708 Installation Guide ni.com...
Page 6
AI Start Trig, AI SAMP CLK, CTR 0 OUT D GND Figure 4. NI TB-2708 Block Diagram For more detailed descriptions of these signals, refer to the S Series User Manual. Additional signal configuration information is available in Measurement &...
Page 7
However, for best results, use the OFF (ground-referenced source) switch position to avoid ground loops. Refer to the S Series User Manual for more information on measuring floating and ground-referenced signals. NI TB-2708 Installation Guide ni.com Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com...
Page 9
Red/White CTR 1 OUT Green/White PFI 9 Blue/White — Table 4 lists the National Instruments cables available for connecting the TB-2708 to both analog and digital user signals. Table 4. TB-2708 Cabling Options Cable Length Part Number SMB-100, SMB Female to BNC 0.6 m...
/60 VDC can damage the TB-2708 and any device connected to it, including the host computer. Overvoltage can also cause an electric shock hazard for the operator. National Instruments is not liable for damage or injury resulting from such misuse.
Waste Electrical and Electronic Equipment (WEEE) EU Customers At the end of their life cycle, all products must be sent to a WEEE recycling center. For more information about WEEE recycling centers and National Instruments WEEE initiatives, visit ni.com/environment/weee.htm Where to Go for Support The National Instruments Web site is your complete resource for technical support.
Page 12
National Instruments corporate headquarters is located at 11500 North Mopac Expressway, Austin, Texas, 78759-3504. National Instruments also has offices located around the world to help address your support needs. For telephone support in the United States, create your service request at and follow the calling ni.com/support...
Page 13
Instruments trademarks. Other product and company names mentioned herein are trademarks or trade names of their respective companies. For patents covering National Instruments products, refer to the appropriate location: Help»Patents in your software, the patents.txt file on your CD, or ni.com/patents.