Page 2
Table 1: Hardware Connections Reset Use this button to reboot or reset your CDA3-35. Press the button and hold it for less than five seconds to reboot the CDA3-35. The CDA3-35 restarts, using your existing settings. Press the button and hold it for more...
Page 3
LEDs This section describes the CDA3-35’s LEDs (lights). Figure 3: LEDs...
Page 4
CABLE connection. Green, steady The CDA3-35 has successfully located and locked onto a downstream frequency on the CABLE connection. The CDA3-35 is engaged in channel bonding on the Blue, steady downstream connection. There is no downstream activity on the CABLE connection.
Problem: None of the LEDs Turn On The CDA3-35 is not receiving power, or there is a fault with the device. Ensure that you are using the correct power adaptor. Using a power adaptor other than the one that came with your CDA3-35 can damage the CDA3-35.
Refer to the previous troubleshooting steps but if the above steps do not work, you can try resetting the CDA3-35. All user- configured data is lost, and the CDA3-35 is returned to its default settings. If the problem persists, contact the Nexicom Helpdesk.