pro user DRC4310DC Operating Manual page 11

Please always pair the monitor and camera before the 1
Testing the back-up camera system after Installation:
1. Check if the vehicle's negative battery cable (ground) has been reattached.
2. Turn the ignition key to the accessory position - do not start the vehicle
3. Engage the parking brake, and put the vehicle´s shifter in the reverse position (backup lights are lit).
If not already done: Please pair your camera to the monitor (as described in paragraph Pairing). The
System should activate itself. If not, press the Power-button on the Monitor
4. After testing (and re-adjusting if needed) the unit, all cabling should be installed permanently:
Route all wires behind interior panels or under carpeting. Use the supplied cable ties to keep excess
wires neat and compact.
NOTE: UNDER EXTREME BRIGHT LIGHT CONDITIONS, THE SCREEN IMAGE MAY TAKE A FEW
SECONDS TO STABILIZE. PLEASE WAIT UNTIL THE IMAGE HAS STABILIZED BEFORE BACKING UP.
Pairing:
Enter the Menu by pressing the MENU-button and select the "Pair" icon with the arrow buttons and press
ENTER. Shortly after, press the rubber button on the bottom of the camera until the signal is received
by the monitor.
Backup-Camera-mode: If the device is in standby, press the POWER button to supply power to the
monitor. The picture on the monitor will automatically turn on or switch from another mode to Backup-
Camera-mode, when the vehicle is in reverse gear (monitor receives video signal from backup-camera).
Orientation:
In the Menu "Picture direction" you can change the orientation of the picture. These different views
allow you to mount the camera and monitor in any position with keeping the right picture on the monitor.
Simply enter the "Picture direction" menu by choosing it and pressing the Power button. The orientation
of the picture will change every time pressing the Power button. To save the settings and exit the screen
please press the menu button.
OPERATION (Backup-Camera)
11
st
operation.