Connecting To The Channel Inserts Of A Mixing Console - Alesis Ineko Reference Manual

connections • chapter 2
Connecting to the Channel Inserts of a mixing
console:
Most mixing consoles have a jack near the mic and line inputs
labeled "Insert". This is typically a TRS jack with the send and
return on the same jack. To use the Ineko as a channel insert, you
will need an insert cable (not included).
Ring:
Insert Return
T Tip:
nsert Send
I
This cable splits the TRS insert jack into two unbalanced mono
connectors. Usually, the tip is connected to the
effects processor and the ring is connected to the
effects processor. However, this may be reversed on some
mixing consoles. Check your mixer's Reference Manual to be
sure or just try it both ways – this won't damage the Ineko. You
may need to raise the mixer's input trim if the signal coming
back from the Ineko is too low.
Ineko In
22
Sleeve:
Insert Ground
Ineko Out
Insert Send:
To Ineko Input
Insert Return:
From Ineko
Output
of the
INPUT
of the
OUTPUT
Mixer Insert
Ineko Reference Manual