Advertisement
Pinion & machine motor
3mm
×4
Pinion and machine motor with cooling block
are supplied as a complete spare part Therefore
the following steps are rarely needed.
Motor
Preparations: disassemble pinion unit follow
ing step 1—2 in the beginning of this
chapter.
DISASSEMBLE AN OLD MOTOR
Disassemble cooling unit
1. Remove spacer fasteners (a) of cooling
unit (b)
– Allen wrench: 3mm
• cut cable lugs and disengage the cool
ing unit
ASSEMBLING A NEW MOTOR
2. Prepare cables as follows:
(w) red and blue cables; cut off any exist
ing cable lugs
(x) remove existing heat shrink tube and
fit on a new as follows:
– shrink new Ø6mm heat shrink
tube (x) approx. 40mm cover
ing red cable
– shrink new Ø6mm heat shrink
tube (x) approx. 40mm cover
ing all cables
(y) black cables for temperature sensor;
keep existing length with cable lug
(z) rubber cable padding; fixate cooling
unit and thread cable bundle through
(w+y)
Assembling cooling unit
• assemble motor to cooling unit (b)
with spacers (reverse step 1a above)
3. cut red and blue cable at 63mm from
cooling unit
– fit new cable lugs to red and
blue cables
CONTINUED REASSEMBLING
After step 2 above; complete assembling of
pinion house as in step 1—2 in the begin
ning of this chapter.
9
25
Advertisement
