Back Up User's Data - Zoom G2.1u Service Manual

Guitar effects pedal

Hide thumbs Also See for G2.1u:

Table of Contents

If necessary, back up the user's effect patch data to avoid an accidental erasing.

Required

· User's G2.1u as a transmitter (hereinafter referred to as "the transmitter")

· Another G2.1u as a receiver (hereinafter referred to as "the receiver")

· Jumper wires

1. Remove the bottom plate.

2. Connect "IN" terminal of the transmitter and "OUT" terminal of the receiver.

3. Connect "OUT" terminal of the transmitter and "IN" terminal of the receiver.

4. Connect their ground terminals on the top side of the main PCB, using jumper wires (See

below).

Transmitter

Main PCB top side

5. Turn the power of both transmitter and receiver on while holding the [STORE] and the

[RHYTHM] keys.

Make sure that the both 7segment LED lit "tr".

6. Press the [TYPE -] key of the receiver, and make sure that the 7 segment LED lit "rx".

The receiver is ready to receive the data.