Table of Contents
Advertisement
REASSEMBLY FOR REBUILD/REPAIR
1. Insert the Fan Adjustment Seal (Fig Q).
2. Insert the Fan Adjustment Ring and Air Distributor Plate (Fig P). NOTE: If you have
separated these two pieces it is critical that the white Air Distributor Plate is correctly
re-inserted into the Fan Adjustment Ring. Note that the open slots on the Air Distributor
Plate must be visible through the holes of the Fan Adjustment Ring. Using the back end of
the Needle assembly, move the Distributor Plate so that the round screw hole is at the
5 o'clock position. DO NOT put the Distributor Plate and Fan Adjustment Ring together at
this point.
3. Place the Air Distributor on top of the paired Fan Adjustment Ring and Air Distributor
plate. Align the screw hole in the Air Distributor with the holes in the Fan Adjustment Ring
and Air Distributor Plate (Figs R1 & R2).
4. Place Air Cap Assembly over Stainless Steel Locating Pin (Figs S & T).
5. Screw the Fluid Nozzle back onto the Spray Gun body, fi nger tight. Rotate the Fan
Adjustment Ring to be sure it rotates freely and easily. Tighten the Nozzle slightly more
with the wrench (included). Rotate Fan Adjustment Ring again. Do not over tighten the
Fluid Nozzle as it will stop the Fan Adjustment Ring from rotating. If too tight, back off
slightly. Be sure that the Fluid Nozzle is not too loose or leaking will occur.
6. Insert the Air Cap Seal (Fig U). To insert, observe both sides of the seal. One side should
have three small circles. This side goes toward the Spray Gun. Snap the Air Cap Seal onto
the Air Distributor.
7. Push the needle back into the spray gun.
– Insert the Needle spring into the Material Adjustment Screw (Fig V).
– Install the Material Adjustment Screw with Needle Spring.
– Install air cap and air cap ring. Spray gun is now re-assembled and ready to use.
To order parts and supplies: 800.345.1178 >> eastwood.com
FIG. U
Air Cap Seal
FIG. V
FIG. O
FIG. P
FIG. Q
Fan Adjustment Seal
FIG. R1
FIG. R2
Correct
FIG. S
Counterbored
FIG. T
Incorrect
Hole
Stainless
Steel
Locating Pin
7
Advertisement
Table of Contents
