Makita 9565CR Instruction Manual page 8

For tool with clamp lever type wheel
guard
► 1. Wheel guard 2. Bearing box 3. Screw 4. Lever
1
► 1. Screw
Pull the lever in the direction of the arrow after loosening the
screw. Mount the wheel guard with the protrusion on the wheel
guard band aligned with the notch on the bearing box. Then rotate
the wheel guard around 180°. Fasten it with the screw after pulling
lever in the direction of the arrow for the working purpose. The
setting angle of the wheel guard can be adjusted with the lever.
To remove wheel guard, follow the installation proce-
dure in reverse.
Installing or removing depressed
center grinding wheel/Multi-disc
(accessory)
1
2
3
► 1. Lock nut 2. Depressed center grinding wheel/
Multi-disc 3. Inner flange or super flange
Mount the inner flange onto the spindle. Fit the wheel/
disc on the inner flange and screw the lock nut onto the
spindle.
To tighten the lock nut, press the shaft lock firmly so
that the spindle cannot revolve, then use the lock nut
1
wrench and securely tighten clockwise.
2
3
4
2
► 1. Lock nut wrench 2. Shaft lock
To remove the wheel, follow the installation procedure
in reverse.
Super flange
Models with the letter F are standard-equipped with a
super flange. Only 1/3 of efforts needed to undo lock
nut, compared with conventional type.
Installing or removing abrasive disc
(optional accessory)
NOTE:
• Use sander accessories specified in this man-
ual. These must be purchased separately.
► 1. Lock nut 2. Abrasive disc 3. Rubber pad
Mount the rubber pad onto the spindle. Fit the disc on
the rubber pad and screw the lock nut onto the spindle.
To tighten the lock nut, press the shaft lock firmly so
that the spindle cannot revolve, then use the lock nut
wrench and securely tighten clockwise.
To remove the disc, follow the installation procedure in
reverse.
8 ENGLISH
1
1
2
3