HAMPTON BAY S5-BRH00800 Use And Care Manual page 9

Assembly (continued)
9
Tightening bolts and placing the tiles
□ After making any necessary adjustments to the parts,
use the hex wrench (CC) to tighten all bolts (AA and BB).
Tighten each bolt a few revolutions at a time. Repeat until
all bolts are tight. Do not over tighten. Over tightening
may strip bolts. Cover all bolts with covers (DD). See the
illustrations in steps 1 - 8 for proper placement of the bolt
covers (DD).
□ Note the clear bumpers spaced evenly throughout the
inside of the table top. Carefully place tiles (R) inside the
table top, resting on the clear bumpers.
11
Testing for leaks
□ Open the tank valve. Apply a solution of soapy water
to the tank-regulator connection and to the valve-hose
connection to check for leaks. If soap bubbles continue to
form, the connection has a leak. If a leak is found, close the
tank valve and tighten all connections.
WARNING:
10
□ Pour the lava rocks (J) into the burner. Completely cover
□ Remove the cardboard cover (1) from the ignition well.
R
12
□ Make sure the control knob is in the "OFF" position.
9
Placing the lava rocks
the burner.
1
Installing the battery
Unscrew the push button cap on the ignition module
located on the control panel to access the battery
compartment. The ignition module requires one Alkaline
WARNING: Dispose of battery safely. May explode or leak
( 1.5V )
AAA BATTERY
COMARTMENT
INSTALL (-) SIDE
FIRST
Please contact 855-HD-HAMPTON for further assistance.
J
IGNITOR
HAMPTONBAY.COM