HAMPTON BAY S5-BRH00800 Use And Care Manual page 8

Assembly (continued)
5
Attaching the table top
□ With the help of another person, carefully place the table
top (L) onto the assembly. After making any necessary
adjustments to the alignment of the table top and the
assembled base, use four ¼ in. x 15 mm bolts (AA) and
washers (EE). Guide the bolts (AA) through the holes in the
side panels and into the pre-drilled holes under the table
top (L). Do not tighten completely.
7
Placing the gas tank
□ Place a gas tank (not included) onto the LP support (Q).
L
EE
AA
DD
Q
8
6
Attaching the LP support
□ Attach the LP support (Q) to the door panel (P) using four
¼ in. x 15 mm bolts (AA) and washers (EE). Do not over
tighten.
8
Connecting the gas tank
□ Attach the metal rings attached to the LP regulator hose (D)
into the holes of the door panel (P) and secure with nuts
(FF). Then use the hex wrench (CC) to screw the ¼ in. x 5
mm nut on the gas tank. Connect the regulator hose (D)
to the tank. Screw the black handle clockwise to tighten.
Turn the handle counterclockwise to remove. The hose
must point down. Check that the valve is turned all the way
clockwise to the "OFF" position.
AA EE
DD
P
Q
FF
P
D
Q