Barthelme CHROMOFLEX Pro Series Instruction Manual page 8

Programs:
1. Fixed colours
2. Normal colour change
3. Medium colour change
4. Slow colour change
5. „Blob"- randomly up lighted/dimmed colours
6. „LSD"- randomly changing colours
7. „Fire" -Fire simulation
8. Flashes
9. „Bursts": Randomly selected, non-synchronised flashes
10. User effect #1 (adjustable via Software ProCEd)
11. User effect #2 (adjustable via Software ProCEd)
12. User effect #3 (adjustable via Software ProCEd)
6. Networking
®
A basic application is using one CHROMOFLEX Pro and either remote control or USB dongle. Both units have
to be set on the same net. This is also the default factory setup mode (default: network 10). When using the
software "ProCEd", various groups can be set to control several nets independently.
The remote control responds to all units within radio range. If the master is out of this range, it will proceed sending
his settings to the slaves. Therefore, it is important that the master is within the range of the remote control.
Fig. 3
®
Note about the range: The Radio Remote Control has a less strong antenna than the CHROMOFLEX Pro
units or the USB dongle. Normally the range of the Radio Remote Control is below the range of the master to the
other units.
7. Contents
®
Every CHROMOFLEX Pro RGB remote control is shipped with this manual. The instructions are an integral
part of the equipment to which they relate and must be handed to the user.
® ®
CHROMOFLEX Pro USB dongle (66000036) and CHROMOFLEX Pro units (66000033; 66000034;
66000043; 66000044; 66000343; 66000344) are optional accessories.
®
Important note: Complete manuals for any CHROMOFLEX can be downloaded at www.barthelme.eu . Please
look for updates before installation.
8. Contact
Josef Barthelme GmbH & Co. KG
Oedenberger Str. 149
D-90491 Nürnberg, Germany
Tel: +49 (0) 911 42 476 0
Mail info@barthelme.eu
Subject to technical changes
®
V1.1 / 12.01.2015 8 / 8 CHROMOFLEX Pro Remote