Lavor INDEPENDENT 2000 Manual page 18

FAULT
The pump doesn't
reach the necessary
pressure
Fluctuating pressure
Water leaking from the
pump
Loss of pressure
Noise
Water is in the oil
Water leakage from
the head
Lance blocked
REPAIRS - SPARE PARTS
For any further inconveniences, not mentioned in this booklet or any demages of the machine, we suggest you to
go to an Authorized Assistance center for the repair or possible replacement of any original spare parts.
DISASSEMBLING OF THE MACHINE
DISPOSAL (WEEE)
As the owner of electrical or electronic equipment, the law (in accordance with the EU Directive
2002/96/EC of 27 January 2003) prohibits you from disposing of this product or its electrical / elec-
tronic accessories as municipal solid waste and obliges you to make use of the appropriate waste
collection facilities.
The product can be disposed of by returning it to the distributor when a new product is purchased.
The new product must be equivalent to that being disposed of.
18
CAUSE
Water inlet filter is clogged
Suction/delivery valves are
clogged or worn out
Lance nozzle incorrect or worn out
Air intake
Valves dirty, worn out or stuck
Sealing worn out
Sealing worn out
The nozzle is worn out
The valves are dirty or blocked
Adjusting valve seal is worn out
Seals are worn out
The filter is dirty
Air intake
Valves are worn out dirty or
blocked
Bearings are worn out
Extreme water temperature
The filter is dirty
O-rings (water and oil) are worn
out.
High moisture in the air
Seals are worn out
O-rings seal system are worn out
Nozzle is dirty
REPAIR
Clean the water inlet filter
Contact an authorised service centre
Check and/or replace
Check that connections and
locking ring are well tightened
Contact an authorised service centre
Contact an authorised service centre
Contact an authorised service centre
Replace the nozzle
Contact an authorised service centre
Contact an authorised service centre
Contact an authorised service centre
Check and/or clean
Check the intake pipes
Contact an authorised service centre
Contact an authorised service centre
Bring the temperature under 40° C
Check and clean
Contact an authorised service centre
Replace oil with double frequency
that is suggested
Contact an authorised service centre
Contact an authorised service centre
Clean nozzle with the pin included
in the unit