Hilti SSH 6­A22 Manual page 13

SSH­CS,
0.5 ­ 1.5 mm,
, for
straight cuts
Starting hole di- 17 mm
ameter
(0.7 in)
Smallest radius 80 mm
for curved cut-
(3.1 in)
outs
5 Preparations at the workplace
CAUTION
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1 Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery.
5.2 Inserting the battery
CAUTION
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the battery holder until it engages with an audible click.
3. Check that the battery is seated securely.
5.3 Removing the battery
1. Press the battery release buttons.
2. Remove the battery from the tool.
6 Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Setting the cutting speed
▶ Set the cutting speed by turning the adjusting knob for motor speed.
6.2 Switching on
1. Press the rear section of the on/off switch.
2. Slide the on/off switch forward.
➥ The motor runs.
3. Lock the on/off switch.
*2253584*
SSH­CS, SSH­CX,
1.5 ­ 2.5 mm, 0.5 ­ 1.5 mm,
, for
straight cuts straight cuts
in stainless
steel
22 mm 20 mm
(0.9 in) (0.8 in)
150 mm 120 mm
(5.9 in) (4.7 in)
2253584
SSH­CC,
0.5 ­ 1.5 mm,
, for , for curves
15 mm
(0.6 in)
L 45 mm (2 in),
R 80 mm
(3.15 in)
SSH­CD,
4 x 0.9 mm,
, for spiral
ducting
18 mm
(0.7 in)
150 mm
(5.9 in)
English 7