Cobra CobraMarine MRHH150FLTE Owner's Manual page 13

Advanced Operation
Operating Your Radio VHF Marine Radio Protocols
Intro Operation Customer
Assistance
Memory Location Mode
Your radio has ten memory locations (numbered 0 to 9) for your most frequently used
FLOATING MARINE HH150
channels. These memory locations can be selected individually or can be scanned.
Customer
To enter Memory mode, press Memory/Escape button. The
Installation
Assistance
MEM/ESC Button
ESC
display will show the MEM icon and the Memory Channel
Secondary Icons
bank will be activated and displayed.
H-M-L
PWR MEM To Program Memory Locations:
1. Press and hold the Memory/Escape button for
two seconds. The memory location number
Notice Caution
CHANNEL
will start flashing.
SC/DW
2. Use the Channel Up and Channel Down buttons to advance
Memory Location Number
to the memory location (0-9) you want to program.
3. Press the Memory/Escape button to select the
VOL
FLOATING MARINE HH150
memory location. The memory channel number
will stop flashing and the channel number will
ESC SETUP
start flashing.
SUBMERSIBLE
4. Use the Channel Up and Channel Down buttons
PWR MEM H-M-L ENTER
to change to the channel you want to store into the
Channel Up/Down Buttons
CHANNEL
selected memory location.
16+
SC/DW
5. Press the Memory/Escape button to program that
channel. The memory location number will flash again.
VOL +
VOL
Repeat steps 2 through 5 to program as many additional
memory locations as you want [up to ten VHF memory
SUBMERSIBLE
channels].
Channel Number 6. Press and hold the Memory/Escape button for two
seconds. This will return the radio to Memory mode.
7. Press and release the Memory/Escape button again to
return to Marine
Standby mode.
20 English
Warranty
SETUP
ENTER
Warning
16+
VOL +
Advanced Operation
Operating Your Radio VHF Marine Radio Protocols
Intro Operation Customer Warranty
Assistance
To Recall a Stored Memory Location:
MEM Icon
1. Press the Memory/Escape button. The MEM icon will be
turned On.
Customer 2. Press the Channel Up or Channel Down button to select
Installation
Assistance
the memory location. If a memory location has been
Secondary Icons
programmed, its associated channel will display on the
LCD. Your radio is now in Marine Standby mode on the
selected memory location.
To Exit Memory Location Mode:
Notice Caution Warning
Press the Memory/Escape button to return the radio
to Marine Standby mode. The last channel used in Marine
Standby mode will now be displayed on the
LCD and the MEM icon will disappear.
To Erase Stored Memory Locations:
1. Press and hold the Memory/Escape button for two
seconds. The memory location number will start flashing
and the MEM icon will be turned On.
2. Use the Channel Up and Channel Down buttons to advance
to the memory location you want to erase.
3. Press the Memory/Escape button to select the memory
location. The memory channel number will stop flashing
and the channel number will start flashing.
4. Use the Channel Up and Channel Down buttons to change
the channel to read "
5. Press the Memory/Escape button to erase that memory
location.
Repeat steps 2 through 5 to erase as many additional memory
locations as you want.
6. Press and hold the Memory/Escape button for two seconds.
This will return the radio to Memory mode.
7. Press and release the Memory/Escape button again
to return to Marine Standby mode.
--
" at the selected memory location.
Nothing Comes Close to a Cobra
® 21