Cobra CobraMarine MRHH150FLTE Owner's Manual page 14

Advanced Operation
Main Icons
VHF Marine Radio Protocols Operating Your Radio
Intro Operation Customer
Assistance
Memory Location Scan Mode
Memory Location Scan
Intro Operation Customer
During Memory Location Scan mode, the radio will rapidly
Assistance
scan through all programmed memory channels. Whenever Customer
Installation
Assistance
any activity is detected on a channel, the radio will stop the
Secondary Icons
scan for 10 seconds to allow you to listen briefly on that
Customer
Installation
Assistance
channel. It will then continue to scan unless you switch out of
Memory Location Scan mode.
Secondary Icons
NOTE
Notice Caution
If there are fewer than two memory locations programmed
Notice Caution
in the radio, the Memory Location Scan option will not
be available. At least two memory locations need to be
programmed to use the Scan button.
FLOATING MARINE HH150
To Enter Memory Location Scan:
1. From Marine Standby mode, press the Memory/Escape
MEM/ESC Button
button.
ESC
FLOATING MARINE HH150
2. Press and hold the DUAL WATCH/SCAN button.
The radio will immediately begin to scan all pre-assigned
memory channels. The SCAN and MEM icons will show on
PWR H-M-L
MEM
ESC
the LCD.
3. A signal on any channel will stop the scan for
CHANNEL
10 seconds to allow you to listen to the traffic
PWR
MEM
on that location.
Scan Button
SC/DW
4. Press the Channel Up or Channel Down button
CHANNEL
to resume scanning the Memory Location Scan
channels or to change the scan direction.
SC/DW
VOL
5. To EXIT Memory Location Scan mode, press and hold the
DUAL WATCH/SCAN button again. The SCAN and MEM
icons will disappear from the LCD and the radio will return
VOL
to Memory mode.
SUBMERSIBLE
SUBMERSIBLE
22 English
Warranty
Warranty
Warning
Warning
SETUP
ENTER
SETUP
H-M-L ENTER
16+
16+
VOL +
VOL +
Advanced Operation
Operating Your Radio VHF Marine Radio Protocols
Intro Operation Customer
Assistance
Channel Scan Mode
Scanning
During Channel Scan mode, the radio will rapidly switch
from channel to channel through ALL the channels. Whenever
Customer
FLOATING MARINE HH150 Installation
Assistance
any activity is detected, the radio will stop the scan for 10
Secondary Icons seconds to allow you to listen briefly on that channel. The
radio will then continue to scan unless you switch out of the
ESC
Channel Scan mode.
To Enter Channel Scan:
PWR MEM
Notice Caution
SCAN Button
1. From Marine Standby mode, press and hold the
DUAL WATCH/SCAN button. The radio will immediately
CHANNEL
begin to scan the entire channel map selected in
SC/DW
the active channel map. The SCAN icon will show
on the LCD.
2. A signal on any channel will stop the scan for
10 seconds to allow you to listen to the traffic
VOL
on that location.
SCAN Icon
3. Press the Channel Up or Channel Down button
to resume scanning the Channel Scan channels
SUBMERSIBLE
or to change the scan direction.
FLOATING MARINE HH150
4. To EXIT Channel Scan mode, press and hold the
DUAL WATCH/SCAN button again. The SCAN icon
ESC SETUP
will disappear from the LCD and the radio will
PWR MEM H-M-L ENTER return to Marine Standby mode.
Channel Up/Down Buttons
CHANNEL
16+
SC/DW
VOL +
VOL
SUBMERSIBLE
Warranty
SETUP
H-M-L
ENTER
Warning
16+
VOL +
Nothing Comes Close to a Cobra
® 23