Transducer Installation - Lowrance HDS Touch Gen2 Manual

Transducer Installation

T r a n s d u c e r C a b l e S h i e l d
E l e c t r i c S t e e r T r o l l i n g M o t o r s
1. Use 12mm x 8mm polyurethane coiled air hose.
2. Cut off 4 coils for 42" shaft and 5 coils for 60" shaft.
3. Use a marker to dot the inside line where the hose will
be split. * VERY IMPORTANT*
4. Secure both ends of the hose to a table with clamps
with the dotted line facing up. Clamping two lengths
of timber to either side of the tubing will help stop it
from rolling when you cut.
5. Split hose along dotted line using a sharp lubricated
Stanley blade.
6. Clip over transducer cable and secure to motor shaft
starting at the bottom allowing the first coil free.
Tip: Lubricate transducer cable with WD40 and dip the hose in water before clipping over cable.
41