SolarEdge StorEdge SE5K-RWS Installation Manual page 39

1. Pass the CAN bus cable through Communication Gland 1.
Figure 16: Connection of CAN Cable from Battery to Inverter
2. Connect the cable to the CAN bus connector.
3. Set the DIP switches on the CAN bus board:
Two right DIP switches - Switch to ON.
Left DIP switch (PIN 2 - PIN 6) - Selects a grounding PIN for the CAN bus
connector. Set according to battery manufacturer's instructions.
StorEdge Three Phase Inverter MAN-01-00648-1.3
Figure 17: DIP switch set-up on the CAN board
Chapter 5: Connecting the Inverter 38