Cisco FMC 1600 Hardware Installation Manual page 6

Features
Table 1: FMC 1600, 2600, and 4600 Features
Feature
Security standards
certifications
Form factor
Rack mount
Airflow
Pullout asset card
Grounding hole
Unit identification button
Power button
Processor
Memory
RDIMMs
Internal component only;
not field-replaceable
Management ports
USB ports
Cisco Firepower Management Center 1600, 2600, and 4600 Hardware Installation Guide
2
1600 2600
• Common Criteria (CC) on FTD 6.4.x
• Federal Information Processing Standards (FIPS) 140-2 on FTD 6.4.x
• Department of Defense Information Network Approved Product List (DoDIN
APL)
• US Government Compliance for IPv6 (USGv6) and Ready Logo certified
on FTD 6.4.x
See the "Security Certifications Compliance" topic in the "Appliance Platform
Settings" chapter in the Firepower Management Center Configuration Guide,
Version 6.7 for the instructions on how to enable security certifications
compliance.
1 RU
Standard 19-in. (48.3 cm) 4-post EIA rack
Front to rear
Cold aisle to hot aisle
Displays the serial number and the MAC address for the two built-in management
ports
Two threaded holes for a dual-hole grounding lug
Use is optional; the supported AC power supplies have internal grounding, so
no additional chassis grounding is required.
On the front panel
On the rear panel
One Intel Xeon 4110 Two Intel Xeon 4110
processors
processor
32-GB RAM 64-GB RAM
Two 16-GB Four 16-GB
DDR4-2400-MHz DDR4-2400-MHz
DIMMs DIMMs
Two built-in RJ-45 SFP+ ports
Support for 1000 Mbps, 1 Gbps, and 10 Gbps
The primary management port is eth0. You can use eth1, eth2, and eth3 as
secondary management or event ports.
Two USB 3.0 Type A
Overview
4600
Two Intel Xeon 4116
processors
128-GB RAM
Eight 16-GB
DDR4-2400-MHz
DIMMs