Cisco FMC 1600 Hardware Installation Manual page 41

Installation, Maintenance, and Upgrade
Warning
Warning
Step 1 Remove the drive that you are replacing:
a) Press the release button on the face of the drive tray.
b) Grasp and open the ejector lever and then pull the drive tray out of the slot.
Figure 33: Remove the Drive
1 Ejector handle
Step 2 Remove the four drive-tray screws that secure the drive to the tray and then lift the drive out of the tray.
Statement 1073 No User-Serviceable Parts
There are no serviceable parts inside. To avoid risk of electric shock, do not open.
Statement 1074 Comply with Local and National Electrical Codes
To reduce risk of electric shock or fire, installation of the equipment must comply with local and national
electrical codes.
Cisco Firepower Management Center 1600, 2600, and 4600 Hardware Installation Guide
2 Release button
Remove and Replace a Drive
37