Jeep CHEROKEE User Manual page 88

6th = 3.7 mph (6 km/h)

7th = 4.3 mph (7 km/h)

8th = 5 mph (8 km/h)

9th = 5.6 mph (9 km/h) – If Equipped

REVERSE = .6 mph (1 km/h)

NEUTRAL = 1.2 mph (2 km/h)

PARK = SSC remains enabled but not

active
NOTE:
During SSC the +/- shifter input is used for

SSC target speed selection but will not
affect the gear chosen by the transmis-
sion. While actively controlling SSC the
transmission will shift appropriately for
the driver-selected set speed and corre-
sponding driving conditions.
SSC performance is influenced by the

Terrain Select mode. This difference may be
notable to the driver and may be perceived
as a varying level of aggressiveness.
86
Driver Override:
The driver may override SSC activation with
throttle or brake application at any time.
Deactivating SSC
SSC will be deactivated but remain available
if any of the following conditions occur:
Driver overrides SSC set speed with

throttle or brake application.
Vehicle speed exceeds 20 mph (32 km/h)

but remains below 40 mph (64 km/h).
Vehicle is shifted to PARK.

Disabling SSC
SSC will deactivate and be disabled if any of
the following conditions occur:
The driver pushes the SSC switch

The driveline is shifted out of 4L Range

The park brake is applied

Driver door opens

The vehicle is driven greater than 20 mph

(32 km/h) for greater than 70 seconds
The vehicle is driven greater than 40 mph

(64 km/h) (SSC exits immediately)
Feedback To The Driver:
The instrument cluster has an SSC icon and
the SSC switch has an LED which offer feed-
back to the driver about the state SSC is in.
The cluster icon and switch lamp will illu-

minate and remain on solid when SSC is
enabled or activated. This is the normal
operating condition for SSC.
The cluster icon and switch lamp will flash

for several seconds then extinguish when
the driver pushes the SSC switch but
enable conditions are not met.
The cluster icon and switch lamp will flash

for several seconds then extinguish when
SSC disables due to excess speed.
The cluster icon and switch lamp will flash

then extinguish when SSC deactivates due
to overheated brakes.
WARNING!
SSC is only intended to assist the driver in
controlling vehicle speed when driving in
off road conditions. The driver must
remain attentive to the driving conditions
and is responsible for maintaining a safe
vehicle speed.