Front Ventilated Seats - If Equipped - Jeep CHEROKEE User Manual

Front Heated Seats — If Equipped
If your vehicle is equipped with front heated
seats, the control buttons are located within
the Uconnect system. You can gain access to
the control buttons through the climate
screen or the controls screen.
Press the heated seat button

turn the HI setting on.
Press the heated seat button

time to turn the LO setting on.
Press the heated seat button

time to turn the heating elements off.
The level of heat selected will stay on until
changed by the operator.
NOTE:
The engine must be running for the heated
seats to operate.
Vehicles Equipped With Remote Start
On models that are equipped with remote start,
the driver's heated seat can be programmed to
come on during a remote start.
This feature can be programmed through the
Uconnect system. Refer to "Uconnect Settings"
in "Multimedia" in the Owner's Manual.
WARNING!
Persons who are unable to feel pain to

the skin because of advanced age,
chronic illness, diabetes, spinal cord
injury, medication, alcohol use, exhaus-
tion or other physical condition must
exercise care when using the seat heater.
once to
It may cause burns even at low tempera-
tures, especially if used for long periods
a second
of time.
Do not place anything on the seat or

seatback that insulates against heat,
a third
such as a blanket or cushion. This may
cause the seat heater to overheat. Sitting
in a seat that has been overheated could
cause serious burns due to the increased
surface temperature of the seat.
Rear Heated Seats — If Equipped
On some models, the two outboard rear seats
are equipped with heated seats. The heated
seat switches for these seats are located on
the rear of the center console.
There are two heated seat switches that allow
the rear passengers to operate the seats
independently. Amber indicator lights in
each switch indicate the level of heat in use.
Two indicator lights will illuminate for HI,
one for LO and none for off.
Push the heated seat button

turn the HI setting on.
Push the heated seat button

time to turn the LO setting on.
Push the heated seat button

time to turn the heating elements off.
NOTE:
Once a heat setting is selected, heat will

be felt within two to five minutes.
The engine must be running for the heated

seats to operate.
When the HI-level setting is selected, the
heater will provide a boosted heat level
during the first four minutes of operation.
Then, the heat output will drop to the normal
HI-level. The level of heat selected will stay
on until changed by the operator.
Front Ventilated Seats — If Equipped
If your vehicle is equipped with ventilated
seats, the seat cushion and seat back will
have fans that draw the air from the
passenger compartment and
through fine perforations in the seat cover to
once to
a second
a third
move air
25